How to Crochet Ribbed Fingerless Gloves with Half Double Crochet

Materials & tools you'll need

Skill level: Intermediate. Uses US crochet terms — front post double crochet (FPdc), back post double crochet (BPdc), half double crochet (hdc).

Step 1 — Start the foundation

Make a slip knot and chain 27. Double crochet into the fourth chain from the hook, then continue double crocheting across the remaining chains to complete the row. Chain two and turn. This foundation row sets the width of your glove.

Step 2 — Work the ribbed cuff

For Row 2, work front post double crochet (FPdc) into the first stitch, then back post double crochet (BPdc) into the second stitch. Continue alternating FPdc and BPdc across the entire row to build the ribbed texture. For Row 3, reverse the pattern — start with a back post double crochet in the first stitch, followed by a front post double crochet in the second, continuing this reversed alternation across the row.

Step 3 — Continue the ribbed cuff

Repeat the same alternating FPdc/BPdc pattern from rows 2 and 3 for rows 4, 5, and 6, continuing to reverse the order every other row. This builds up the full ribbed cuff detail around the wrist, giving the glove a snug, stretchy edge before transitioning into the body.

Step 4 — Work the glove body in half double crochet

Switch to half double crochet (hdc) for the main body of the glove. Work ten rows of half double crochet stitch across, from row 7 through row 17. This creates a smooth, even texture that contrasts with the ribbed cuff and covers the rest of the hand.

Step 5 — Assemble the gloves

Once you've completed all 17 rows, fold the mitt over to bring the two long edges together. Weave in the yarn tail on one side and reattach at the cuff, or use the working yarn from the ball to assemble. Insert your hook into the side without the yarn, yarn over with the working tail, and pull it through. Slip stitch through the first three stitches on both sides together to close the top edge. From there, continue slip stitching on just one side — not through both layers — for the next seven rows of the ribbed section, leaving the other side open to form the thumb gap, until you reach the cuffed edge. At the cuff, work one extra chain stitch and fasten off to close that edge neatly. Weave in all remaining ends — your fingerless gloves are ready to wear.

Frequently asked questions

What is the pattern for the ribbed texture on these fingerless gloves?
Row 2 alternates front post double crochet and back post double crochet across the row, then Row 3 reverses that order — starting with back post double crochet followed by front post double crochet. Repeating this alternating, reversing pattern through rows 2 to 6 creates the ribbed detail around the cuff.

What size are the finished ribbed fingerless gloves?
The finished gloves measure approximately 14cm (5.5 inches) from cuff to fingertip, with the finger opening portion measuring approximately 7cm (2.8 inches).

Can I use a different yarn weight for this pattern?
Yes. The pattern is written for a wool synthetic blend yarn with a 4.0mm hook, but a 5mm aluminum hook also works well — adjust your hook size to suit the yarn weight you're using, keeping in mind the finished gloves may run slightly larger or smaller as a result.

Enjoyed this tutorial?

Find 60+ free tutorials on YouTube. Grab a pattern from the Etsy shop, or go deeper with a community membership.

Free tutorials on YouTube →    Shop on Etsy →    Join the community →